The examinations for combined first and second semester B.Tech Degree finished on last month and wishing all the candidates a good result. Edudrive here attaching the question papers for the subjects Engineering Graphics and Basic Mechanical engineering 2008 scheme for the reference of new aspirants of engineering.
To draw isometric views for the orthographic diagram shown here LIST OF COMMANDS USED Line, Hatch, Snap, Ortho, Isometric grid PROCEDURE 1. Set Ortho on. 2. Enter Snap command, enter G for grid style and the I for isometric then press enter. 3. Enter Isometricgrid and select T or top 4. Enter Line command 5. Select start point 6. Specify next point: 40 7. Specify next point : 15 8. Specify next point : 20 9. Specify next point : 15 10. Specify next point : 20 11. Specify next point: 60 12. Specify next point: 80 13. Specify next point: 60 and close 14. Enter Isometricgrid command and enter R for right 15. Select Line command 16. Select start point left corner end 17. Specify next point: 55 18. Specify next point: 15 19. Specify next point: 20 20. Select star
Comments
Post a Comment
Thank You for your valuable comment....
arish ibrahim